Kleenmaid RH14 - Manual (Page 7)

7 - Intensive speed ON switch
This speed should be used when the
concentration of cooking fumes or
odours
are particularly strong (for
example when frying, cooking fish etc)
.
The fast speed will run for about 5
minutes and then return to the speed
previously set automatically (1, 2 or 3),
or switch off if no speed was selected.
To turn off the fast speed, before the
end of the 5 minutes, press button 1 or
button 2
.
8 - OFF lamp button
9 - ON lamp button
If the
rangehood fails to operate correctly,
briefly disconnect it from the mains power
supply for approximately 5 seconds by
pulling out the plug. Then plug in again
and try once more before contacting your
Technical Assistance Service Centre.
Slider switches panel
Two are the switches:
- One for turning the lamp ON and OFF.
- One for lighting ON and selecting the
motor speed.
Warning!
—The
rangehood cannot be connected to
flues of other appliances that run on
energy sources other than electricity.
—When the
rangehood is used at the same
time as other appliances that run on
energy sources other than electricity,
provision must be made for an adequate
supply of air.
— No food must be cooked flambé
underneath the
rangehood.
The use of an unprotected flame is
dangerous for the filters and could cause
fires.
Therefore, never use an open flame
under the
rangehood. When frying foods,
never leave the pan alone because the
cooking oil could flare up.
— Please keep to the provisions of official
directives regarding the question of fume
discharge.
— The manufacturers refuse to accept any
responsibility for damage to the
rangehood
or its catching on fire because of failure
to observe the above instructions.
Maintenance
Before performing any maintenance
operation, isolate the
rangehood from
the electrical supply by switching off at the
connector and removing the connector fuse.
If the appliance has been connected through
a plug and socket, then
to isolate, the plug
must be removed from the socket.
Metal grease filter (2 or 3 pieces)
The metal grease filter
s last forever and
must be washed either by hand or in the
dishwasher (65°C) with suitable detergents.
NOTE: The metal grease filters may discolour
however this will not affect their performance.
Model with slider switches panel
The metal grease filters must be washed at
least once a month.
Model with electronic control panel
The metal grease filters must be washed at
least once a month
or whenever the LED 4
indicates the saturation of the
filter.
Th
e LED flashes to warn you when the metal
grease filters need to be cleaned.
Generally, these must be cleaned after 40
hours of use.
Once the grease filters have been cleaned,
press button 1 for about
3 seconds until
you hear the acoustic signal
(beep): the
LED 4 will now
stop flashing.
Remove the metal grease filter using the
handles designed for this purpose by
pulling the filter backwards and then
downwards (Fig. 1).
Let the metal grease filter
s dry without
damaging before
putting back into place.
Carry out the above steps in reverse order
to put the metal grease filters back after
having washed them.