Kleenmaid FEC605W - Manual (Page 25)

Instructions for use, installation and connection 25
Oven drawer
• The oven drawer is protected from accidental
opening.
• It may be opened by lifting upwards. To remove
the drawer from the cooker pull it out to the
limit, then lift upwards and pull out completely.
• Never place any flammable or explosive
substances in the drawer.
The drawer is equipped with side slides on
wheels. To insert it back, slide the wheels into the
slide guides and push inwards.
Levelling the appliance and extra
support
The height of the cooker with the support is 90
cm, and without support it is 85 cm. Left and right
side of the support is equipped with two wheels to
facilitate relocation. In the front part, on both
sides there are two adjustable screws, used to
level the cooker and adjust its upper edge in line
with the adjacent kitchen furniture.
Adjustable legs are accessible when the drawer
is pulled out. Adjust the position of the cooker by
turning the legs in one direction or another.
Adjustable legs will be turned easier if the
appliance is somewhat lifted up and tilted.
Additional support may be removed by
unscrewing the four screws holding it to the
bottom of the cooker.
Some cookers are equipped with four adjusting
screws (two in front and two at the back), used
for levelling the appliance or adjusting its heights
to match the adjacent furniture.
Electrical connection
Open the connection box using the
screwdriver, as shown by the drawing on
the cover.
Connection to the mains power can be done only
by the authorized service center or by qualified
personnel!
Wrong connection may damage the parts of
appliance and render your warranty viod!
Connecting voltage of the user’s installation (230
V against N) must be verified by qualified
electrician using the appropriate tester.
Connector bridges must be positioned in
accordance with the installation connection!
• Prior connecting the appliance, check whether
the voltage of the rating plate corresponds to
the actual voltage of home installation.
• Length of the power lead must be at least 1.5 m
so that the appliance can be connected to
power before pushing it against the wall.
• Length of the earthing lead must be longer than
the others, so that it is strained later than the
tension power leads in case of accidental
pullout from the socket.
Procedure
• Using the screwdriver open the connection box
cover at the back of the appliance. You can do
so by releasing two catches, as shown on the
connection box cover.
• Power cable must be guided through the relief
device, protecting it from pulling out. If the relief
device has not been fixed yet, fix it in such way
to hook the power cable to the device housing
at one end.
• Now connect the power cable in accordance to
one of the options shown on the figure. In case
of different installation voltages, the connection
bridges should be rearranged accordingly!
• Tighten the relief device and close the
connection box cover.