Kleenmaid CH805CE-1 - Manual (Page 16)

172736
• Connections may be carried out by a qualifi ed technician only. The earthing protection must
comply with the standing regulations.
• Connection terminals are revealed when the connection box cover is removed.
• Prior any attempted connection check that the voltage indicated on the rating plate is in line with
your home power supply.
• The rating plate is located underneath the appliance.
• The appliance is manufactured for use with the power supply voltage AC 230 V.
• The electric wiring should be equipped with a circuit breaker able to isolate the appliance from
the mains in all points, with the distance between terminals of at least 3 mm in open position.
This may be done by means of fuses, safety switches, etc.
• The connection should be selected in accordance with the declared charge capacity of the mains
and the fuse power.
• Such appliances are allowed to be mounted on one side next to a high kitchen cabinet, the
height of which may exceed that of the appliance. On the opposite side however, only a kitchen
cabinet of equal height as the appliance is allowed.
• Upon the completion of installation, live wires and isolated cables must be adequately protected
against accidental touching.
• Distance between the cooktop surface and the cooking hood must be such as indicated in the
instructions for use of the hood.
• Kitchen cabinets may not be mounted underneath the built-in ceramic-glass cooktop.
Upon each connection to the power supply the sensors of the
appliance are automatically adjusted to the environment to
ensure their proper function. All displays indicate the sign “-”.
Once the successful adjustment is completed it is signaled with
a beep, all displays are switched off and your cooktop is ready
for use.
During the adjustment procedure the sensors must be free of any
objects, otherwise the adjustment procedure will be interrupted
until such objects are removed from the sensor surface. During
this period the regulation of the cooktop is impossible.
ATTENTION !
Before attempting any repairs on the appliance, disconnect
the power supply. In accordance with the mains voltage the
appliance should be connected in line with the attached diagram.
The earthing wire (PE) must be connected to the terminal
marked with the earthing symbol .
The connection cable must lead through the relief safety device,
protecting it from accidental pulling out.
Upon the completion of installation switch all the hotplates on for
about 3 minutes to check the proper functioning.
16
Connection to the power supply
Basic adjustment of
sensors to the ambience
172731_en.indd 16 172731_en.indd 16 9.1.2007 14:52:05 9.1.2007 14:52:05