Kleenmaid CH80X User Manual
Page 14
12
3 - A
DJUST THE LOW FLAME SETTING OF THE TAPS
, located un-
der the control knobs, proceeding as follows:
Working on each burner in turn.
•Light the burner at maximum position.
•Remove the control knob for the corresponding tap as
well as the airtight seal.
•Using the screwdriver, supplied in the bag, unscrew
the yellow, brass, adjustment screw (see drawings oppo-
site) turning it round twice, anti-clockwise.
•Replace the control knob and turn it to low flame set-
ting.
•Remove the control knob again, then turn the adjuster
screw clockwise to the lowest position before the flame
goes out, replace the control knob and the airtight seal
and turn the tap from full on to low flame several times to
check the adjustment : the flame should not go out ;
otherwise, adjust the setting by tightening or loosening
the adjuster screw slightly until a steady flame is obtai-
ned when the knob is operated.
•Replace the airtight seals and the control knobs, ma-
king sure they turn in the correct direction.
To carry out this operation you must do the following in order:
1- A
DAPT THE GAS CONNECTION
(p.9)
2- C
HANGE THE INJECTORS
3- A
DJUST THE LOW FLAME SETTING OF THE TAPS
2 -
CHANGE THE INJECTORS
, proceeding as follows:
• Remove the pan supports and all the burner caps and
heads.
• Using a 7 socket, supplied in the wallet, unscrew the
injectors located in the base of each burner pot and
remove them.
• Replace them, in accordance with the table on page
14, screwing them down manually, then, using the soc-
ket, screw in a quarter turn at the most.
• Replace the burner heads and caps and the pan
supports.
P
P
a
a
r
r
t
t
2
2
:
:
F
F
o
o
r
r
t
t
h
h
e
e
i
i
n
n
s
s
t
t
a
a
l
l
l
l
e
e
r
r
Changing gas
(cont.)
Changing from LPG to natural gas