Kemppi TTC-TIG torches - Manual (Page 9)

EN
rTC 10 (code 6185477)
Besides the start-switch there is a potentiometer for controlling the welding current.
S = start
U (clockwise) = welding current will slope-up
D (anticlockwise) = welding current will slope-down
rTC 20 (code 6185478)
Besides the start-switch there is a seesaw switch for controlling the welding current.
S = start
U = welding current will slope-up
D = welding current will slope-down
Assembly instruction is delivered with the regulators.
2.3 adjusTmenT OF TOrCh bOdy and grips
You can draw the torch neck outwards from inside the handle in approx. 30 mm length in
order to grow reach or to minimize heat radiation to welder’s hand. You can also twist the
torch body 360° in regard of the handle. Twisting of neck makes the length adjustment easier.
Before starting to weld make sure that the parts being exposed to voltage at the back end of
the neck body are not visible.
7
TT
C / © Kemppi O
y / 1130