Kemppi Minarc 150 - Manual (Page 8)

© KEMPPI OY 8 – MINARC 150, 151 / 0531
4.2. TROUBLESHOOTING
Main switch signal light is not lit.
Unit does not get electricity.
 Check mains fuses and replace when necessary.
 Check mains cable and plug, replace damaged parts.
Unit does not weld well.
Arc is uneven and goes off. Electrode gets stuck in weld pool.
 Check welding settings and adjust when necessary. See 3. Use.
 Check that earth clamp is properly fixed and that contact surface is clean and the cable is
undamaged. See 3.4. Welding and 4.1. Daily maintenance.
Overheat signal light is lit.
The unit has overheated. See 3.2. Operating functions.

Check that there is ample space in front of and back of the unit for ventilation.
 Check welding settings. See 3.3. Welding selections.
If problems in use are not solved with above mentioned measures, please contact a Kemppi service
workshop.
4.3. DISPOSAL OF THE MACHINE
Do not dispose of electrical equipment together with normal waste!
In observance of European Directive 2002/96/EC on Waste Electrical and Electronic
Equipment and its implementation in accordance with national law, electrical equipment
that has reached the end of its life must be collected separately and returned to an
environmentally compatible recycling facility. As the owner of the equipment, you should
get information on approved collection systems from our local representative.
By applying this European Directive you will improve the environment and human
health!
5. ORDERING NUMBERS
Item Ordering number
Minarc 150 welding machine 6102150
(includes earth- and welding cables)
Minarc 151 welding machine
6101151
(includes earth- and welding cables)
Earth cable and clamp
6184015
Welding cable and electrode holder 6184005
Carrying strap
9592162
Optional:
TIG torch TTM15V, 4 m
6271432