Kemppi Evo 200 - Manual (Page 6)

EN
2. BefOre yOu start using the unit
NOTE! Please read the separate safety instruction booklet provided before you commence welding.
Pay particular attention to the risks associated with fire and explosion.
2.1 unpacking
Always before using the equipment, make sure it was not damaged during transportation.
Also check that you have received what you ordered and that there are instructions for it.
The packaging material of the products is suitable for recycling.
transportation
The machine should be transported in an upright position.
NOTE! Always move the welding machine by lifting it from the handle. Never pull it from the
welding torch or other cables.
environment
The machine is suitable for both indoor and outdoor use, but it should be protected from rain
and sunshine. Store the machine in a dry and clean environment and protect it from sand and
dust during use and storage. The recommended operating temperature range is -20 °C – +40 °C.
Place the machine in such a way that it does not come in contact with hot surfaces, sparks and
spatters. Make sure the air flow in the machine is unrestricted.
2.2 positioning and location of the machine
Place the machine on a firm, dry and level surface. Where possible, do not allow dust or other
impurities to enter the machines cooling air flow. Preferably site the machine above floor level;
for example on a suitable carriage unit.
Notes for positioning the machine
• The surface inclination should not exceed 15 degrees.
• Ensure the free circulation of the cooling air. There must be at least 20 cm of free space in
front of and behind the machine for cooling air to circulate.
• Protect the machine against heavy rain and direct sunshine.
NOTE! The machine should not be operated in the rain as the protection class of the machine,
IP23S, allows for outside preserving and storage only.
NOTE! Never use a wet welding machine.
NOTE! Never aim metallic grinding spray/sparks towards the equipment.
2.3 Distribution network
All regular electrical devices without special circuits generate harmonic currents into
distribution network. High rates of harmonic current may cause losses and disturbance to
some equipment.
MinarcTig Evo 200 and MinarcTig Evo 200MLP complies with IEC 61000-3-12.
2.4 serial number
The serial number of the unit is marked on the rating plate. The serial number makes it
possible to trace product manufacturing series. You might need the serial number when
placing spare parts orders or when planning maintenance.
MinarcTig Evo 200, 200MLP
4