Kemppi Adaptive 170 - Manual (Page 12)

EN
2.6 CONTROLS AND INDICATOR LIGHTS
2
3
4
1
1. Welding power control
2. Arc length trimmer
3. Standby indicator light
4. Overheating indicator light
The welding power is adjusted according to the thickness of the welded
sheet. The machine also has a trimmer for arc length.
Indicator lights display the machine’s standby mode and inform of a possible
overheating.
When you switch the machine on, a green standby light switches on.
Simultaneously, the main switch indicator light switches on. If the machine
overheats or the supply voltage is too low or too high, the welding operation
automatically switches off and the yellow overheating indicator light
switches on. The light switches off when the machine is ready for operation
again. Make sure that there is enough space around the machine allowing air
to freely flow and cool the machine.
10
M
inar
cM
ig 170 / © Kemppi O
y / 1117