Kemppi Adaptive 170 User Manual

Page 11

NOTE!

When driving the wire in to the gun, do not point the gun at yourself or

others or put, for example, your hand in front of the tip, because the cut wire end

is extremely sharp. Also, do not put your fingers near the feed rolls, because they

might get squeezed between the rolls.

2.5.3 Reversing polarity

Some filler wires are recommended to be welded with the gun in the –pole,

so the polarity should be reversed. Check the recommended polarity from

the filler wire package.

1. Disconnect the machine from the mains.

2. Bend the rubber cover of the earthing cable’s pole in such way that the

cable can be disconnected.

3. Remove poles’ tightening nuts and washers. Note the correct order of

the washers!

4. Interchange the cables.

5. Install the washers in place and close the tightening nuts to spanner

tightness.

6. Put the rubber cover of the earthing cable’s pole firmly in place. The

rubber cover must always protect the earthing cable’s pole.

inar

y / 1117