Kemppi MagTrac F 61 User Manual

Page 15

3.3.11 Weld data selections (WELD DATA)

MagTrac F 61 records useful information about the latest welding session. Select Weld data

menu to check the data.

Menu item

Description

Length of the latest weld.

TOT ARC (m)

Total welded length of the latest welding session.
Does not include the non-weld length in cycle welding.

TOT ARC (min, s)

Total time of the latest welding session.
Does not include the non-weld time in cycle welding.

CURRENT

Average welding current during the latest welding session.

VOLTAGE

Average welding voltage during the latest welding session.

HEAT

Heat input in the latest welding session in kJ/mm.

RESET WELD DATA

This resets all weld data settings.

3.3.12 Setup selections (SETTINGS)

Select this menu to check or change the MagTrac F 61 settings. The settings are stored in the

carriage memory.

Menu item

Values

Description

CONTRAST

Change the contrast of the carriage display.

RESTORE SETTINGS

YES, NO

Restore the parameter values to their initial settings.

PANEL INFO

PANEL SW
SYSTEM SW
PRG DATE

Open information about the carriage software: Control panel
version, system version and the date of the carriage software.

Initial parameter settings
When you use the RESTORE SETTINGS function, the parameter settings are restored to the

following values:

Parameter

Factory value

ARC ON

OFF (welding arc is off)

DIRECTION

RIGHT (carriage travels to the right)

CONTRAST

20 (contrast of the control panel display)

CYCLE WELD

OFF (cycle welding is not in use)

WELD LENGTH

50 mm (length of the welded section in cycle welding).

IDLE LENGTH

50 mm (length of the non-welded section in cycle welding).

CYCLE COUNT

CONT (cycle welding continues until it is stopped )

LAST WELD LENGTH

0 mm

TOT ARC

0 mm (total arc length in the latest welding session)

TOT ARC

0 min 0 s (total arc time in the latest welding session)

CURRENT

0 A (average current in the latest welding session)

VOLTAGE

0 V (average voltage in the latest welding session)

HEAT

0.0 kJ/mm (heat input in the latest welding session)