Kemppi ArcFeed 200 - Manual (Page 16)

EN
5. mAintenAnCe
5.1 dAily mAintenAnCe
Do the following always before starting to use the machine:
• Check the tightness of the earthing cable connections.
• Check the condition of mains and welding cables and replace damaged cables.
• Make sure that all extension cables used in the mains connection are in proper condition
and compliant with regulations.
NOTE! The mains cables may be repaired and installed only by electrical contractors and installers
authorised to perform such operations.
5.2 regulAr mAintenAnCe
All electromechanical devices require routine service maintenance depending on usage. This
type of routine maintenance will prevent hazards and malfunctions.
We recommend that you schedule a service inspection of your welding machine every six
months. An authorised Kemppi service agent will inspect and clean your machine, ensuring
that all power connections are tight and secure. Power connections can become loose and
oxidised with frequent and high changes in temperature.
NOTE! Disconnect the machine from the mains power supply before handling electric cables.
5.3 dispOsAl OF the mAChine
Do not dispose of electrical equipment with normal waste!
In observance of European Directive 2002/96/EC on waste electrical and electronic
equipment, and its implementation in accordance with national law, electrical equipment
that has reached the end of its life must be collected separately and taken to an appropriate
environmentally responsible recycling facility.
The owner of the equipment is obliged to deliver a decommissioned unit to a regional
collection centre, per the instructions of local authorities or a Kemppi representative. By
applying this European Directive you will improve the environment and human health.
14
A
rcF
eed 200, 300, 300P
, 300R
C / © Kemppi O
y / 1117