Kemppi ArcFeed 200 - Manual (Page 12)

EN
4. using the mAChine
Before starting to use the Kemppi ArcFeed wire feeder, you must be aware of the power
source type you are using ( either CC, constant current, or CV, constant voltage). The suitable
welding wire for the welding application must also be loaded in the feeder. For more
information, see Chapter 3.
4.1 using the COntrOl pAnel FunCtiOns
1
2
3 4 5
6
7
1. ON/OFF switch
2. Gun operating mode selector (2T/4T)
3. CC/CV mode selector
4. Selector of the wire feed speed scale
5. Control knob.
6. Polarity indicator light
7. LCD display
4.1.1 switching the machine on and off
To turn on the machine, set the main switch (1) to position ON. The LCD display of the control
panel lights up, and the machine is ready for use.
4.1.2 selecting the CC or Cv mode
With the CC/CV switch you can choose between constant current (CC) and constant voltage
(CV) type of power source. Set this switch according to the power source you are using. See
the documentation of the power source to find its type.
10
A
rcF
eed 200, 300, 300P
, 300R
C / © Kemppi O
y / 1117