Dimplex TDS8515 - Manual (Page 9)

9
of internal heater parts and will not occur again.
Resetting the Temperature Cutoff Switch
This unit is equipped with a thermostat which controls the temperature
of the room. It does this by turning the heater on and off. The heater
is protected with a safety device to prevent overheating. Should the
heater overheat, an automatic cut out will turn the heater off and it will
not come back on without being reset. It can be reset by switching
the Main ON/OFF Switch to OFF and waiting five (5) minutes before
switching the unit back on.
CAUTION: If you need to continuously reset the heater, unplug the
unit and call your local dealer.
Remote Control Usage
The stove is supplied with a radio frequency remote control. This
remote control has a range of approximately 50 feet (15.25 m). It
does not have to be pointed at the stove and can pass through most
obstacles (including walls). It is supplied with one of 243 independent
frequencies to prevent interference with other units. The frequency
designation is indicated on the back of the transmitter (Figure 4).
The remote control operates the stove levels sequentially. The level is
increased every time the ON button on the transmitter is pressed. The
stove can be turned off at any point by pressing the OFF button on the
remote control transmitter.
Level 1: The flame effect is turned on and the first red indicator is
activated.
Level 2: The flame effect remains on, the Purifire™ is activated, and
the first and second red indicator lights are activated.
Level 3: The flame effect and Purifire™ remain on, the heater is
activated, and all three red indicator lights are activated.
!
NOTE: When the stove is turned on by transmitter the stove will
start with flames only. The level can be increased every time the
ON button on the transmitter is pressed.