Purifire™ filter – Dimplex TDS8515 User Manual
Page 12
12
4. Remove the burnt out bulb(s)
by pulling straight out of
socket. If bulbs are difficult to
remove from socket move the
bulb from side to side while
pulling being careful not to
damage the light socket.
5. Replace the lower light bulbs.
6. Reassemble in the reverse
order as above.
Purifire™ Filter
The Purifire™ filter supplied in
your stove is reusable and
washable. The filter should be
cleaned or replaced on average
once a year. To clean the filter
gently tap filter on a hard surface
to dislodge any loose dirt or
debris, and then clean with
water. No soap or cleaning
products are recommended.
The filter size is 20 inches x
10 inches x 1 inch, rated at
MERV 10. If using an after
market filter follow the
manufacturers recommended
replacement instructions.
To replace filter (Figure 7):
1. Remove the two (2) screws
at the upper corners of the
back panel.
2. Lift the back end of the top to
clear the brackets and pull
back.
3. Lift top carefully, and place to the side of the stove.
Upper Light
Bulb
Lower Light
Bulbs (3)
Figure 5
Figure 6
Screws
Screws