JLCooper ES-450SP4 - Manual (Page 6)

6
Configuration
Before using the ES-450SP4, we recommend setting it up for the
various ways you may need to use it in.
Frame Rate
This setting is used to set the frame rate used in Frame+1 and
Frame-1 calculations. This is done by pressing SHIFT + STOP.
This will switch between the following frame rates:
• 24 (Film)
• 25 (PAL)
• 30 (NTSC)
Track Arming Mode
This determines how the audio track arming is handled. This is
toggled by pressing SHIFT+REWIND. The options are:
• Type 1 (Default)
Older decks with 2 analog tracks.
A1 = Analog Audio 1 (This is sometimes interpreted as
Digital Audio 1 in some decks)
A2 = Analog Audio 2 (This is sometimes interpreted as
Digital Audio 2 in some decks)
Shift + A1 = Analog Audio 3 (TC in some decks)
Shift + A2 = Analog Audio 4 (Sync in some decks)
• Type 2
Sends a 2 byte track arm message with the A1 & A2 bits
copied from the D1 & D2 bits. Tally back uses byte 5 of
the Status message.
A1 = Analog Audio 1 and Digital Audio 1
A2 = Analog Audio 2 and Digital Audio 2
Shift + A1 = Digital Audio 3
Shift + A2 = Digital Audio 4