JLCooper ES-450SP4 - Manual (Page 14)

14
2. Enter Record Ready mode
3. Switch to Record mode at the Mark In point
4. Revert to Record Ready mode at the Mark Out point
5. Stop the tape at the Mark Out point plus the postroll
Timecode Window
The Timecode Window displays the timecode that the device sends
via the 9-pin interface. This is usually the longitudinal timecode of
the media. Some devices will send timecode derived from VITC, a
dedicated timecode track or the control track. The timecode is
displayed in hours:minutes:seconds:frames format. Drop frame
timecode is indicated by a small dot or period between “LTC” and
the hours field.
TC= 01:25:36:12
Non-Drop frame timecode
TC=
.
01:25:36:12
Drop frame timecode