Jetway Computer NF93R - Manual (Page 35)

30
3-6 PC Health Status
This section shows the Status of you CPU, Fan, and Warning for overall system status. This
is only available if there is Hardware Monitor onboard.
Phoenix – AwardBIOS CMOS Setup Utility
PC Health Status
Item Help
CPU FAN Configuration Press Enter
SYS FAN1 Configuration Press Enter
SYS FAN2 Configuration Press Enter
Shutdown Temperature Disabled
VCC 3.3 3.34V
VSB 3.36V
Voltage Battery 3.36V
CPU Temp 42
SYS Temp 47
CPU Fan Speed 6482RPM
SYS1 Fan Speed 0RPM
SYS2 Fan Speed 0RPM
Menu Level >
↑↓→← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values F6:Optimized Defaults F7:Standard Defaults
CPU FAN Configurations
CPU Full-Speed Temp
This item allows you setting the FAN works in full speed when the temperature over the value
which out set. If the temperature below the value but over the Idle Temperature, the FAN
will works over 60% of full speed, and the higher temperature will gain higher FAN speed,
after over the temperature which this item setting, the FAN works in full speed.
CPU Idle Temp
This item allows you setting the FAN works in 60% of full speed, when the temperature
lower than the temperature which you setting.