beautypg.com

Jetway Computer NC9NDL User Manual

Page 34

background image

29

EHCI Hand-off

The optional settings are: [Disabled]; [Enabled].

USB hardware delays and time-outs:

USB Transfer time-out

Use this item to set the time-out value for control, bulk, and interrupt transfers.

Device reset time-out

Use this item to set USB mass storage device start unit command time-out.

Device power-up delay

Use this item to set maximum time the device will take before it properly reports

itself to the host controller. ‘Auto’ uses default value: for a root port it is 100 ms, for

a hub port the delay is taken from hub descriptor. The optional settings: [Auto];

[Manual].Select [Manual] you can set value for the following sub-item:

Device Power-up delay: the delay range in from 1 to 40 seconds in one second

increments.

Super I/O Configuration

COM1 Port Configuration

Press [Enter] to make settings for the following items:

Serial Port

Use this item to enable or disable serial port (COM).

Change Settings

Use this item to select an optimal setting for super IO device.
COM2 Port Configuration

Press [Enter] to make settings for the following items:

Serial Port

Use this item to enable or disable serial port (COM).