Denso PRO 60 - Manual (Page 17)

OPERATION (cont.)
How to Set a Program
➀ Setting a START TIME
Press the Program SET button. The Program SET button and START
TIME LEDs will illuminate. Press the HRS and MIN buttons to set the
START TIME.
➁ Setting an END TIME
Press the Program SET button until the END TIME LED illuminates.
Press the HRS and MIN buttons to set the END TIME.
➂ Setting the CLOCK TIME
Press the Program SET button until the SET CLOCK LED illumi-
nates. Press the HRS and MIN buttons to set the current clock time
into the unit.
NOTE: The AM/PM LED will change with the HRS button.
➃ Programming the Temperature SET POINT
Press the Program SET button until the current SET POINT tempera-
ture display begins to flash on and off. Select a new desired SET
POINT temperature by pressing the SET TEMP buttons (
▼ / ▲ ).
➄ Programming the Fan Speed
Press the Program SET button until one of the Fan Speed button
LEDs (High/Low) begin to flash. This is the current programmed Fan
Speed. To change the programmed Fan Speed, simply press the
other Fan Speed button.
➅ Exiting the Program SET Function
After changing any of the above settings, continue pressing the
Program SET button until the Program SET button LED turns off.
The unit will then return to the previous mode.
➆ Activating/Deactivating a Preset Program
Press the Program RUN button to activate/deactivate a preset
program. The Program RUN LED will illuminate when activated.
11