InSinkErator C1300 - Manual (Page 5)

9 8
Electric Shock Hazard: To prevent electrical shock, disconnect power before
servicing unit. Use only a properly grounded and polarized electric outlet.
Only use mild cleaners to clean
the dispenser’s faucet and
plastic components.
Cleaners with acids, alkaline,
and organic solvents will result
in deterioration of the plastic
components and void the warranty.
CLEANING THE FAUCET AND TANK
Factory temperature pre-set is
200˚F. To reset the thermostat
to 200°, turn the indicator two
notches to the right of vertical.
Adjust the thermostat
slowly, turning the dial
clockwise to increase
temperature or counter clockwise to
decrease temperature, then activate faucet
handle for 20 seconds to bring in fresh
water to be heated at the new setting. Allow
5-7 minutes for water to reach new tem-
perature.
Property Damage:
Regularly inspect the unit for any
signs of leakage. If there are signs
of water damage, turn off the water
supply and contact an authorized
InSinkErator Service agent.
A drain pan, plumbed to an
appropriate drain or outfitted with
a leak detector, should be used in
those applications where any
leakage could cause property damage.
NOTICE
Anytime the instant hot water dispenser is not used for
extended periods of time, unplug and drain unit. If it is
below freezing you will need to unplug the unit and drain it.
SEASONAL STORAGE/DRAINAGE
Disconnect power from unit (unplug unit).
Push hot water dispenser faucet lever
and allow water to flow until it is cool.
Shut the cold water supply off at the valve.
Disconnect tubes from the tank.
Unhook tank from wall.
Hold tank upside down and drain the
water into the sink.
Towel dry any water drippings from
tank area.
Reinstall tank to wall and reconnect tubes.
To put back into working order, turn on
cold water supply at valve. Depress the
hot water dispenser faucet lever and
hold until water flows from the spout.
Reconnect the electrical cord. (Refer to
Step 6B)
CARE AND USE
approx. 200°
Scalding Hazard: Do not allow
water to boil. May result in
severe burns.
ADjUSTING THE THERMOSTAT
IMPORTANT SAFETY INFORMATION
Fire Hazard: To minimize possibility of fire, DO NOT store flammable items such as rags,
paper or aerosol cans near the tank. DO NOT store or use petrol or other flammable vapours
and liquids in the vicinity of this or any other appliance.
Leak Hazard: Regularly inspect dispenser and plumbing fittings for leaks, which can
cause property damage and could result in personal injury
A steaming hot water tap, like any water heater, has a limited life and will eventually fail. To avoid possible property
damage and personal injury, this steaming hot water tap should be regularly examined for leakage and/or corrosion and
replaced when necessary. A drain pan, plumbed to an appropriate drain or outfitted with a leak detector, should be used
in those applications where any leakage could cause property damage.
n Use this water heater only for its intended use as described in this manual.
n This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction
concerning use of appliance by a person responsible for their safety. Children should be supervised to ensure that
they do not play with hot water tap. To reduce the risk of injury, close supervision is required when an
appliance is used near children.
n Do not operate this product if it has been or appears to be damaged in any manner or after the product
malfunctions, or is dropped. Return the complete product immediately to your retail dealer for inspection, and
if necessary, adjustment or repair.
Important: Always arrange the power cord so that it cannot come in contact with hot surfaces.
n Do not disconnect the product from the power supply by pulling on the cord.
n Do not use the product for other than its intended use as described in these instructions. The use of accessory
attachments other than those recommended by the manufacturer may cause safety hazards.
n The recommended connection may be made to an existing cold water line with a branch terminating with a shutoff
valve, a pressure relief and dual check non-return valve sited adjacent to the product.
Electric Shock Hazard: To reduce the risk of electric shock, do not immerse or expose
the product, flexible cord or plug to rain, moisture or any liquid or when standing in
or on damp or wet surfaces. If any electrical product falls into water, UNPLUG it
immediately. DO NOT REACH INTO THE WATER. Important: Prior to reconnecting to the
power supply, the product should be inspected by a qualified technician.
To reduce the risk associated with the ingestion of contaminants: Do not use with water
that is microbiologically unsafe or of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction may be used on disinfected water
that may contain filterable cysts. EPA Establishment #070595-CT-001.
Personal Injury/Property Damage: To reduce the risk associated with hazardous volt-
age due to an installer drilling through existing electric wiring in the area of installation:
Do not install near electric wiring which may be in path of a drilling tool when selecting
the position to mount the system bracket.
Also avoid the risk of drilling into water pipes which may result in property damage.
This appliance must be earthed (grounded). This steaming hot water tap is equipped with a cord that has a grounding
conductor and earth ground pin. The plug must be connected to an appropriate outlet that is properly installed and earthed
(grounded) in accordance with all local codes and ordinances. Do not modify the plug provided with the appliance – if
it will not fit the outlet, have a proper outlet installed by a qualified electrician. Check with a qualified electrician or
tradesman if you are in doubt as to whether the steaming hot water tap is properly earthed (grounded).
Electric Shock Hazard: Using an ungrounded (no earth ground) or improperly
connected appliance can result in serious injury or death from electrical shock.
To reduce the risk associated with choking: Do not allow children under 3 years of age to
have access to small parts during the installation of this product.
Personal Injury/Property Damage: This tank is a non-pressurized tank. DO NOT modify
this system. DO NOT close vent tube or connect other types of taps or valves to the tank.
Use only the InSinkErator tap supplied. Use only parts provided. Contact an authorized
InSinkErator Service agent for repairs or replacement components.