InSinkErator LC-50 - Manual (Page 8)

8
Electrical Connections
Push wires into disposer (do not displace cardboard
shield) and replace electrical cover plate.
19
Connect white to white and black to black or red
with wire nuts (not included); ground wire to green
grounding screw. Unit must be grounded for safe and
proper installation.
1
2
18
Turn disposer over and remove electrical cover plate.
Pull out wires. DO NOT REMOVE CARDBOARD SHIELD. With electrical supply turned off, insert cable connector
(not included) and run electrical cable through access
hole on bottom of disposer. Tighten cable connector.
16 17
ELECTRICAL SHOCK
• Disconnect power before installing or servicing
unit. Test the circuit with a voltmeter or circuit
tester to ensure the power is off.
• Use only a properly grounded and polarized
electric outlet.
• Improper connection of the equipment-grounding
conductor can result in a risk of electric shock.
• Installation must conform to all local
electrical codes.
• All control centers and disposers must
be grounded.
PERSONAL INJURY/PROPERTY DAMAGE
If the electrical installer is not experienced in
electrical installation, we recommend seeking
competent professional assistance. Disposer or
accessory damage due to improper installation is
not covered under warranty. All installations must
comply with local electrical codes.