Dell MX003 - Manual (Page 31)

25
A UDIBLE I NDICATORS
When the scanner and “MX” receiver are in operation, they provide audible
indications. These sounds indicate the status of the scan and scanner.
One Beep When the “MX” Receiver first receives power, the unit will
beep once.
If the scanner successfully reads a bar code, the green
light will flash. If the “MX” receiver successfully receives
the data from the MS6130, the “MX” will beep once.
Razzberry Tone If, upon power up, the scanner emits a razzberry tone,
then the scanner has failed diagnostics.
The “MX” receiver will emit a razzberry tone if an invalid
bar code is scanned while the receiver is in program
mode.
The “MX” receiver can be programmed to emit a
razzberry tone when the timeout occurs during
communication between the host and receiver.
Refer to the MS4120 Programming Guide section,
Audible Indicators for Communication Timeouts to
program this feature.
Two Beeps The MS6130 scanner will quietly beep twice when
scanning a bar code if the batteries become low.
Three Beeps When scanning the MS6130 Enter/Exit Program Mode
bar code in the MS4120 Programming Guide, the green
LED will flash three times while the scanner
simultaneously beeps three times. When exiting the
program mode, the same visual and audible indications
will occur. After this sequence is completed, the red LED
will turn off. When scanning the Enter/Exit Program Mode
for the Receiver bar code, the “MX” receiver will beep
three times to indicate it is in or exiting out of the program
mode.
(continued next page )