Dell MX003 - Manual (Page 22)

16
E NABLING THE MS700 I /MS720 I S CANNER ’ S RF L OW S PEED
O PTION
Before beginning this procedure, perform all steps in the sections, Matching
the Transmitter to the Receiver and Configuration of the MS700i/MS720i
with “MX”.
Use the MS700i/MS720i scanner to scan the following bar codes.
1. Temporarily cover the bar code below Step 3. Scan the following bar
code to enter program mode.
(The MS700i scanner will beep three times):
Enter/Exit Program Mode for the Receiver
0 1 2 3 4 5 6 6 6 6 6 7
2. Temporarily cover the bar code in Step 1. Scan the Enable RF Low
Speed Option bar code below Step 3.
3. Exit program mode by scanning the bar code in Step 1 again.
Enable RF Low Speed Option
0 1 2 3 4 5 1 2 9 1 5 5