Dremel 1200 - Manual (Page 2)

2
Read and understand all instructions. Failure to follow all instructions
listed below may result in electric shock, fire, and/or serious personal
injury.
SAVE THESE INSTRUCTIONS
Melted glue will burn
skin; operating nozzle
temperature is 380 deg F. Do not touch
melted glue or nozzle area. If accidental
contact occurs, do not remove glue.
Immediately put burned area into cold
water. Always wear protective clothing,
safety glasses, gloves, long sleeve shirt
and long pants. Keep out of reach of
children. Keep away from flammables.
Unplug when not in use. No user service-
able parts inside. Manufacturer assumes
no responsibility for consequential or indirect
damages from the use of this product.
Handling the coated
electrical wires of this
product exposes you to lead, a chemi-
cal known to the State of California to
cause cancer, birth defects and other
reproductive harm. Wash hands after
handling.
Do not attempt to melt
crayons or candles. Do
not use any material other than recom-
mended glue sticks. Permanent damage
to the glue gun could result.
The glue gun is on as soon as it is plugged
in. Do not leave unattended.
When glue gun is hot, do not lay on its
side. Always use stand.
Do not use hot melt glue to replace
structural fasteners. The adhesive used
with this glue gun will begin to soften at
140 deg F. Don't use the glue on objects
that will be subjected to temperatures of
140 deg F or above.
Avoid accidental discharge. Do not touch
glue stick or trigger except to dispense
glue. Feeding or pushing glue stick with
too much force into heated gun may cause
hot glue to be unexpectedly expelled from
nozzle or to flow back from inlet tube.
Do not pull glue sticks from gun. The feed
mechanism may become damaged or
impaired. If you desire to change types of
glue, cut off protruding end and feed the
remainder through with the new type of
glue.
Do not store the glue gun in direct sunlight
for extended periods.
Never attempt to force cool the gun after
use by immersing any part of it in water or
any other liquid. Allow the gun to air cool
only. Allow glue gun to cool before storing.
Do not change nozzles while glue gun is in
“on” position, plugged in, or warm to the
touch. Before changing nozzles, make
sure glue gun is cool to the touch,
unplugged, and the switch is in the “off”
position.
This appliance has a polarized plug (one
blade is wider than the other.) To reduce
the risk of electric shock, this plug is
intended to fit in a polarized outlet only one
way. If the plug does not fit fully in the
outlet, reverse the plug. If it still does not
fit, contact a qualified electrician. Do not
modify the plug in any way.
This glue gun contains no user serviceable
parts. Do not use glue gun if cord is
damaged. Damaged cords increase the
risk of electric shock.
WARNING !
Glue Gun Safety Instructions
WARNING !
WARNING
!
CAUTION
!
DM 2610933927 11-05.qxd 4/12/06 4:20 PM Page 2