Assembly instruction, Pt4000 – ikan PT4000 User Manual

Page 3

ASSEMBLY INSTRUCTION

Attach the Mounting Bracket (Part J) to the back of the 20”

monitor using 4 x Short Phillip’s head screws (Part H).

The two flaps of Part Js should be perpendicular to the

monitor control buttons.

Attach the 20” T-slot with Metal Bracket (Part P) to the

assembled parts. You will use 2 x T-plates (Part C) and

4 x Long Phillips Head screws (Part G) to do so. Make

sure to evenly tighten all screws in this assembly.

Attach 4 x T-slot Nuts (Part D) and 4 x Long Phillips Head

Screws (Part G) as shown on the diagram.

PT4000

20” TELEPROMPTER

Part-I

Part-M

Part P

Attach L-Bracket (Part I) to 8” T-slot (Part M) using 2 x

T-plates (Part C) and 4 x Long Phillips head screws (Part

G). Refer to illustration below for configuration. The

L-Bracket’s (Part I) top half should be flush with the

edge of the 8” T-slot (Part M). Arrange the long section

of Part I attached to Part M.

Part-G

Part-C

PT4000

Rear view of 20” monitor

PT4000

Rear view of 20” monitor

Part-D

Part-G

Part-H

Part-J

Note: Do not completely tighten any screws until you have positioned

the monitor on the T-Slot.

Note: Make sure to tighten the

Long Phillips head screws down

as tight as possible. This will

support the weight of the monitor.

2 of 10

This manual is related to the following products: