Dual XDMA6415 - Manual (Page 7)

7
Press to RESET the unit upon initial installation or if abnormal
operation occurs. Reset button is located behind the faceplate.
With the unit on, press and hold DISP until the clock begins to
flash, then release. Press TUNE nn to adjust the hours and
TUNE
ll
to adjust the minutes. Press DISP momentarily to
save the selected time.
The clock will display 12-hour AM/PM time in USA frequency
spacing mode (PM 10:00). In European frequency spacing
mode, the clock will display 24-hour time (22:00).
Press and hold AUDIO/MENU for more than 3 seconds to
access the setup menu. Press AUDIO/MENU momentarily to
select between the menu functions and rotate the volume knob
left/right to adjust or activate the desired function.
Reset
Set the Clock
12/24-hour Clock
Setup Menu
General Operation
XDMA6415 OPERATION
Setup Menu
Menu Function Options Action
Loudness Curve LOUD OFF Disables the loudness function.
LOUD ON Enables the loudness function. Activating this feature will
enhance the bass and treble frequencies when listening to
music at low volumes.
Tuner Frequency
Spacing
FREQ USA Programs the unit to USA tuner spacing.
(200kHz for FM and 10kHz for AM)
FREQ EUR Programs the unit to European tuner spacing.
(50kHz for FM and 9kHz for AM)
Clock Display CLK OFF Programs the unit to not display the clock when the power is off.
CLK ON Programs the unit to display the clock when the power is off.
Auxiliary Input AUX ON Enables the front panel 3.5mm auxiliary input.
AUX OFF Disables the auxiliary input.
Beep Confirmation BEEP OFF Disables the confirmation beep.
BEEP ON Enables the confirmation beep.
Local/Distance
Tuning
LOC OFF Activates distance tuning.
LOC ON Activates local tuning for strong station reception only.
Subwoofer SB-W ON Enables the subwoofer RCA output
SB-W OFF Disables the subwoofer RCA output
Power on Message MSG OFF Disables power on message.
MSG ON Enables power on message to be displayed.
Demonstration
Mode
DEMO OFF Disables the demonstration message.
DEMO ON Enables the "BLUETOOTH – IPOD – USB" message.
Note: Refer to page 24 for Bluetooth setup menu options.