beautypg.com

IBEA IB-2750 User Manual

Page 12

background image

12

Push model
1. Take the machine to where it will be used.
2. Verify the amount of material to be collected.
3. Consequently use the lever to adjust the working height

of the machine.
Pull up the adjustment rod with your right hand.
By pushing your left hand on the handlebar you will be
able to modify the working height.
When you have achieved the ideal height, let go of the
adjustment rod. (See fig. 6).

Operating instructions
1. Check that the high tension wire is on the spark plug.
2. Move the throttle lever to

position (Fig. 9).

3. Press the pump (fig. 5) three times to enrichen the carbu-

ration.

4. Move the stop switch in operating position (Fig. 7).
5. Slowly pull the starter handle until the cord is streched

tight and then pull hard to start the engine (Fig. 8).

Self-propelled model
To start the self-propelled model, proceed as described
above and then as follows:
1. If you push the traction bar against the handlebars, the

machine will begin to move forward (see fig. 10).

2. To stop the machine or move it backwards, let go of the

traction bar.

OPERATING INSTRUCTIONS

A

ATTTTEEN

NTTIIO

ON

N::

FFoorr sstta

arrttiinng

g uup

p w

wiitthh eenng

giinnee a

allrreea

ad

dyy hheea

atteed

d iitt iiss

nnoott nneecceessssa

arryy ttoo p

prreessss tthhee PPrriim

meerr p

puum

mp

p..

TToo ssoop

p tthhee eenng

giinnee m

moovvee tthhee tthhrroottttllee lleevveerr ttoo tthhee SSTTO

OPP

p

poossiittiioonn..

A

ATTTTEEN

NTTIIO

ON

N::

B

Beeffoorree uunnzziip

pp

piinng

g tthhee b

ba

ag

g,, m

ma

akkee ssuurree tthhee eenng

giinnee

iiss ooffff a

annd

d tthhee rroottoorr hha

ass ssttoop

pp

peed

d..

Precautions during use (Fig. 10)

1. Keep people and animals away from the cut-
ting area.
2. Operate only with grassbag in position.
3. Keep hands and feet away from the chute door
and the rotor under the deck.
4. Always wear headset to protect your ears from
excessive noise during operation.

8 - MAINTENANCE

Adjustment of the traction cable
After the first hours of use it is possible that the traction
handle cable loosens and it becomes difficult to use.
If this happens, adjust the cable regulator (Fig. 11).
The adjustment is correct when the traction goes into action
with a distance of 30 mm between the traction handle and
the handlebar (Fig. 12).

Replacement of the oil in the sump
1. Place the machine on a flat surface.
2. Start the engine and run it for about 1 minute until the oil

warms up and becomes more liquid. Turn the engine off;
take the cap off the spart plug and empty the fuel tank.

3. Remove the oil tank cap and pull the dipstick out.
4. Turn the machine on to its left side so that the oil drops

out into a container (Fig. 13).

See paragraph dealing with replacement of oil for refill.

Servicing the air filter
Clean the air filter every 25 hours. Replace it every season.
(See engine manual for further information).

A

ATTTTEEN

NTTIIO

ON

N::

M

Ma

akkee ssuurree tthhee eenng

giinnee iiss ooffff a

annd

d tthhee p

plluug

g d

diissccoonn--

nneecctteed

d..

This manual is related to the following products: