IBASE IB825 - Manual (Page 30)

BIOS SETUP
26 IB825 User’s Manual
BIOS SETUP UTILITY
Advanced
IDE Configuration
Options
Disabled
Compatible
Enhanced
<- Select Screen
↑↓
Select Item
+- Change Field
F1 General Help
F10 Save and Exit
ESC Exit
ATA/IDE Configuration [Compatible]
Legacy IDE Channels [SATA Pri, PATA Sec]
► Primary IDE Master : [Not Detected]
► Primary IDE Slave : [Not Detected]
► Secondary IDE Master : [Not Detected]
► Secondary IDE Slave : [Not Detected]
Hard Disk Write Protect [Disabled]
IDE Detect Time Out (Sec) [35]
ATA(PI) 80Pin Cable Detection [Host & Device]
The IDE Configuration menu is used to change and/or set the configuration of the
IDE devices installed in the system.
ATA/IDE Configuration
(1) Disabled.
(2) Compatible.
(3) Enhanced
Legacy IDE Channels
(1) SATA Only.
(2) SATA Pri, PATA Sec.
(3) PATA Only
BIOS SETUP UTILITY
Advanced
Configure Win627UHG Super IO Chipset
Allows BIOS to Select
Serial Port Base
Addresses
<- Select Screen
↑↓ Select Item
+- Change Field
F1 General Help
F10 Save and Exit
ESC Exit
Serial Port1 Address [3F8/IRQ4]
Serial Port2 Address [2F8/IRQ3]
Serial Port2 Mode [Normal]
Serial Port3 Address [3E8]
Serial PortC IRQ [IRQ11]
Serial Port4 Address [2E8]
Serial PortD IRQ [IRQ10]
Parallel port Address 378
Parallel Port Mode Normal
Parallel Port IRQ IRQ7
Restore on AC Power Loss [Power Off]
Power On Function None