IBASE MB950 - Manual (Page 31)

BIOS SETUP
MB950 User’s Manual 27
BIOS SETUP UTILITY
Main
Advanced
PCIPnP Boot Security Chipset Exit
IDE Configuration
<- Select Screen
↑↓ Select Item
+- Change Field
Tab
Select Field
F1 General Help
F10 Save and Exit
ESC Exit
Mirrored IDER Configuration [Enabled]
Configure SATA#1 as [IDE]
SATA#1 IDE Configuration [Compatible]
SATA#2 IDE Configuration [Enhanced]
► Primary IDE Master : [Hard Disk]
► Primary Slave Master : [Not Detected]
► Secondary IDE Master : [Not Detected]
► Secondary IDE Slave : [Not Detected]
► Third IDE Master : [Not Detected]
► Fourth IDE Master : [Not Detected]
► Primary IDE Master : [Not Detected]
► Fifth IDE Master : [Not Detected]
► Fifth IDE Slave
► Sixth IDE Master
► Sixth IDE Slave
Hark Disk Write Protect
IDE Detect Time Out (Sec)
ATA(PI) 80Pin Cable Detection
Jmicron 36x ATA Controller
: [Not Detected]
: [Not Detected]
: [Not Detected]
{Disabled}
[35]
[Host & Device]
[Enabled]
The IDE Configuration menu is used to change and/or set the
configuration of the IDE devices installed in the system.
Hard Disk Write Protect
Disable/Enable device write protection. This will be effective only if
device is accessed through BIOS.
IDE Detect Time Out (Sec)
Select the time out value for detecting ATA/ATAPI device(s).
ATA(PI) 80pin Cable Detection
Select the mechanism for detecting 80pin ATA(PI) cable.
Jmicron 36x ATA Controller
Select ATA Controller Operate Mode