Hyundai 2012 Accent User Manual

Page 270

What to do in an emergency

Distributing the sealant
11. Immediately drive approximately

2 miles (3 km) to evenly distribute
the sealant in the tire.

Setting the tire inflation pressure
12. After driving approximately 2

miles (3 km), stop at a suitable
location.

13. Connect connection hose (9) of

the compressor directly to the tire
valve.

14. Connect between compressor (5)

and the vehicle power outlet using
the cable and connectors (3).

15. Adjust the tire inflation pressure

to 32 psi (220 kPa). With the igni-
tion switched on, proceed as fol-
lows.

- To increase the inflation pres-

sure: Switch on the compressor
(6), position I. To check the cur-
rent inflation pressure setting,
briefly switch off the compressor.

✽

✽ NOTE
The pressure gauge may show high-
er than actual reading when the
compressor is running. To get an
accurate tire reading, the compres-
sor needs to be turned off.

To reduce the inflation pres-

sure: Press the button (8) on the
compressor.

16. Remove the speed restriction

label(0) from the sealant bottle(1)
and place it in a highly visible
place in the vehicle such as on
the steering wheel to remind you
not to drive too fast.

WARNING

Do not let the compressor run for
more than 10 minutes, otherwise
the device will overheat and may
be damaged.

CAUTION

Do not exceed a speed of 35
mph (60 km/h). If possible, do
not fall below a speed of 12 mph
(20 km/h).
While driving, if you experience
any unusual vibration, ride dis-
turbance or noise, reduce your
speed and drive with caution
until you can safely pull off of
the side of the road.
Call for road side service or tow-
ing.

CAUTION

Be careful not to overinflate the
tire and stay away from the tire
when filling it.