beautypg.com

What to do in an emergency – Hyundai 2012 Santa Fe User Manual

Page 305

background image

6 3

What to do in an emergency

2. When the vehicle is stopped, turn on

your emergency hazard flashers, set
the parking brake and put the transaxle
in P (automatic transaxle) or reverse
(manual transaxle).

3. Have all passengers get out of the

vehicle. Be sure they all get out on the
side of the vehicle that is away from
traffic.

4. When changing a flat tire, follow the

instruction provided later in this sec-
tion.

F020300AFD

If engine stalls while driving

1. Reduce your speed gradually, keeping

a straight line. Move cautiously off the
road to a safe place.

2. Turn on your emergency flashers.
3. Try to start the engine again. If your

vehicle will not start, contact an
authorized HYUNDAI dealer or seek
other qualified assistance.

F030100AUN

If engine doesn't turn over or
turns over slowly

1. If your vehicle has an automatic

transaxle, be sure the shift lever is in N
(Neutral) or P (Park) and the emer-
gency brake is set.

2. Check the battery connections to be

sure they are clean and tight.

3. Turn on the interior light. If the light

dims or goes out when you operate the
starter, the battery is discharged.

4. Check the starter connections to be

sure they are securely tightened.

5. Do not push or pull the vehicle to start

it. See instructions for "Jump starting".

F030200AFD

If engine turns over normally but
does not start

1. Check fuel level.
2. With the ignition switch in the LOCK

position, check all connectors at igni-
tion, coil and spark plugs. Reconnect
any that may be disconnected or
loose.

3. Check the fuel line in the engine com-

partment.

4. If the engine still does not start, call an

authorized HYUNDAI dealer or seek
other qualified assistance.

IF THE ENGINE WILL NOT START

WARNING

If the engine will not start, do not
push or pull the vehicle to start it.
This could result in a collision or
cause other damage. In addition,
push or pull starting may cause the
catalytic converter to be over-
loaded and create a fire hazard.