Hummer 2010 H3 - Manual (Page 340)

10-74 Vehicle Care
2. Tilt the tire. Separate the
tire/wheel retainer (B) from the
guide pin. Pull the pin through
the center of the wheel. Tilt the
tire/wheel retainer (B) down
through the center wheel
opening.
3. Make sure the tire/wheel
retainer (B) is fully seated across
the underside of the wheel.
4. Assembly the two jack handle
extensions (F) and wheel
wrench (G).
5. Insert the hoist end of the
extension tool (I) through the
hoist shaft access ramp (H).
6. Raise the tire part upward. Make
sure the tire/wheel retainer (B) is
seated in the wheel opening.
7. Raise the tire fully against the
underside of the vehicle by
turning the wheel wrench
clockwise until you hear
two clicks or feel it skip twice.
You cannot overtighten the
cable.