Dual XDVDN8290 - Manual (Page 93)

XDVDN8290 OPERATION
92
Troubleshooting
Bluetooth
Problem Cause Action
Please connect first
appears in the display
There is no mobile device connected to the head unit Pair and or connect a mobile device to the head unit as
described on page 77
Mobile device will not
connect to the head unit
Bluetooth function is not active on the head unit Activate Bluetooth function as described on page 21
Bluetooth function is not active on the mobile device Refer to the owner's manual of your mobile device
A mobile device is already connected to the head unit
This head unit can only be connected to one device at
a time Disconnect current mobile device first, then connect
desired mobile device
ERROR! Connect Timeout
appears in the display
The time limit for the pairing mobile device has been
reached Pair the mobile device within 120 seconds
Pairing Fail appears in
the display
The attempted pairing process has failed Retry the pairing process again
Mobile device will not
connect to the head unit
automatically
The Connect function is set to Manual. When the
Connect function is set to Manual, the head unit will
not connect to any mobile device automatically Set Connect function to Auto as described on page 76
Ring tone can not be
heard through the
speakers
Ring tone volume is turned down Increase the volume of the ring tone using the rotary
encoder during the ringing process
MUTE function is activated on the head unit Press MUTE to cancel the mute function and resume
audio
Echo or noise is heard
during a phone call
Possible road noise or interior interference Close all open windows and turn off any fans or A/C
Microphone opening on the front panel is obstructed Clear any obstacles in front of microphone opening
Call is connected
(but no audio can be
heard through the
speakers)
Audio is routed to the mobile device Press Audio Transfer to allow audio from the phone to
be heard through the speakers
Bluetooth audio is heard through the front channel
speaker outputs or the front preamp outputs only Adjust fader forward so there is audio to the front
speakers. If amplifiers are used only, be sure to use
front preamp outputs
Bluetooth mode includes memory volume.
If Bluetooth volume is set to 0 when a call comes in,
no audio will be heard Adjust Bluetooth volume level above 0
Call is answered
automatically
Auto Answer function is set to On Set Auto Answer function to Off as described on page
77
Caller ID does not appear
during incoming call
The calling mobile device is not set to send the Caller
ID or, the service is not available Some devices may not communicate or work properly
with this head unit
XDVDN8290 does not ring
when receiving a call
Cell phone ringer is set to off Set cell phone ringer to “on”
Dual Electronics Corp.
Toll Free: 1-866-382-5476
www.dualav.com
©2007 Dual Electronics Corp. All rights reserved.
NSA1207-V01
Printed in China