Hypertherm PAC500 Product Configuration - Manual (Page 51)

2-12 PAC-500
QUICK REFERENCE TO CABLE / HOSE DIMENSIONS
PAC-500 System - No Options (Ref. Fig. 1.15)
The following figures are one-to-one representations of the PAC-500 interconnecting cables and
hoses for single-torch systms. Cables and hoses that would lay in the rail or in the cutting machine's
cable/hose carrier are represented on the following pages. (Use these figures as a guide for multi-
torch systems if cables and hoses will be sharing the same rail or cable/hose carrier. Double the
number of hoses/cables for 2-torch systems, triple the number for 3-torch systems, etc.) System
block diagrams are referenced for each figure pair. Arrangement of cables and hoses laying in rails
or carriers are roughly suggested here.
Figure 2.14 Cables / Hoses in Machine Cable/Hose Carrier - No Options
12
1-1/2"
1/2" 1/2"
1 2 3 4
6
Key - Figure 2.14
6 Torch Leads -
Control Console to Torch
1-1/2" Shielded Torch Leads
1/2" Gas Lead
1/2" Inj. Water Lead
12
7/8"
7/8"
5/8" 5/8" 5/8"
Key - Figure 2.13
3
A PS Leads - PS to Cntrl Csl
7/8" Negative Lead - PS/Cntrl Csl
7/16" Control Cable - PS/Cntrl Csl
8a or 8b Flowmeter or Op Panel Leads -
Flowmeter or Op Panel to Cntrl Csl
1/2" Gas In
1/2" Gas Out
1/2" Inj. Water In
1/2" Inj. Water Out
1/2"* Control Cable (Included with
Op Panel Leads only)
G Gas Supply Hose - Gas Supply to
Cntrl Csl
10 Cooling Water Hose Set - Water
Supply or Water Chiller to Cntrl Csl
3d† Negative Lead - PS to Cntrl Csl
(Used in systems delivering more than
500 Amps)
Figure 2.13 Cables / Hoses in Rail - No Options
7/16" 1/2" 1/2" 1/2"*
1/2" 1/2"
3
A
8a or 8b
G 10 3d†
1 2 3 4