Danby DBC128BLS - Manual (Page 9)

Installation Instructions - Door Swing Reversal
8
1. Unplug the unit from the electrical outlet (if con-
nected) and lay it on it’s back.
2. Remove the screws from the lower hinge assembly as
shown in
Figure F.
3. Pull the door downward to remove it from the
cabinet of the Beverage Center.
4. Remove the cap from the top left side of the
door (
Fig G) and reinstall it on the top right side.
5. Remove the three (3) screws supporting the
top hinge (
Fig H).
6. Remove the plastic caps from the left side of
the frame (
Fig I) and reinstall them on the right
side of the frame (the previous hinge location).
9. Install the upper hinge assembly on the left
side of the frame.
10. Carefully reposition the door firstly into the
upper hinge assembly then onto the cabinet.
11. While the door remains closed install the
lower hinge assembly.
12. Close the door and return the unit into it’s
upright position (
wait 60 mins before re-connect-
ing power to the beverage center), verify the
door alignment and proper seal against the cabi-
net.
FIG I
Plastic Caps (2)
Upper Hinge
FIG G
Door Plug
Lower Hinge Assembly
and Door Support Bracket
FIG F
FIG H