Highgear CompassHi - Manual (Page 8)

- When setting CS/CR/CU, press S1 to select between Count Down
Stop “CS”, Count Down Repeat “CR” and Count Down Up “CU” functions.
- After all adjustments are completed, press S4 to exit the setting mode.
- Press S1 to start the timer, a flag at the perimeter of the LCD will
start rotating anti-clockwise when the timer is counting down.
- Press S4 to stop the timer, the flag at the perimeter of the LCD will
stop rotating. Then press S1 to re-start the timer or press S4 again to
reload the preset timer time.
Remarks:
1. The timer is of 1-second resolution and with working range up to 23 hours 59
minutes 59 seconds.
2. There are 3 kinds of timer function, Count Down Stop “CS”, Count Down Repeat “CR”
and Count Down Up “CU” can be selected.
3. For Count Down Up “CU” function, the timer can count up to 24 hours and then stop
automatically.
4. If preset timer time is less than 30 seconds, the watch will beep for 1 second when
the timer counts down to zero. And if preset timer time is equal to or more than 30
seconds, the watch will beep for about 10 seconds when timer counts down to zero.
Press any button can stop the “Beep” sound.
5. If there is no button operation for 2-3 minutes in setting mode, the watch will return
back to Timer mode automatically.
6. If 24-hour display format is selected for time mode, there will be no “PM” flag at
Timer mode.
J. HOW TO USE THE ALARM AND CHIME
- Press S3 to show Alarm mode, mode prompt “AL” will be displayed for
1 second.
- Press S1 to select “A1” (alarm 1), “A2” (alarm 2) or “AL” (chime).
- “A1”/ “A2” and T1/T2 are shown at the upper row, alarm time and
status are shown at the middle row, and date of alarm is shown at the
lower row of the LCD for alarm time display.
- “AL”, chime status and time are shown at the upper, middle and lower
row of the LCD respectively for chime display.
- At alarm time display, press and hold S4 for 3 seconds to enter
setting mode. The hour digits start flashing.
- With each press of S1, the selected digits or T1/T2 to be adjusted
(flashing) can be made. Press and hold S1 for fast setting.
- With each press of S3, next digits or T1/T2 for setting can be
selected. The sequence is shown as follow:
T1 / T2 DAY
MINUTE MONTH HOUR
S3
S3
S3 S3
S3
1 second auto