Highgear AltiTech 2 - Manual (Page 14)

26
english
25
english
Change altitude units
Change the display units for altitude between Feet and Meters
using a press & hold of the s2 key. Continue to hold the key
until the altitude units icon stops flashing.
MaX/aCC sCrolling Message
When you enter the altiMeter mode, the top line of the display
will show you your MaXiMuM and aCCuMulated altitude
since the last time you cleared the memories.
note: To skip the scrolling message, QuiCK press the
s1, s2 or s3 keys.
note: To see MaXiMuM and aCCuMulated
altitudes during use, QuiCK press the s1 key To
Clear the MaXiMuM and aCCuMulated
MeMories, see Set Altimeter section.
altitude loCK
If the altitude does not change significantly for a period of
30-minutes the Summit/Altitech will automatically activate the
altitude loCK function. altitude loCK is indiCated By
the Weather iCons appearing on the altiMeter
display. When the unit enters the Altitude Lock mode, the
altitude at that time is locked in memory and will not change in
response to gradual external barometric pressure changes. You can
unlock the Altitude Lock function at any time simply by pressing
any key. The Altitude Lock function will automatically deactivate if
it detects any major change in pressure/altitude over a short period
of time.
Primary Screen
Calibrate Screen
Change Units Screen
altimeter screens
Primary Screen
Calibrate Screen
Change Units Screen
altimeter screens alTImeTer alTImeTer daTa loG memory
storing data points
At any time in the Altitude display, press and hold the s1 key for
a period of approximately 3-seconds. During this time the top line of the
display will show the word store, and data will flash in the middle
line with the number of the Data Point appearing in the lower display
line.
When the Data has been stored in memory, the top line will change
from store to stored. Release the s1 key and the unit will return to
the altitude display after approximately 2-seconds.
retrieVing data inForMation
Advance to the altitude data (Alti DATA) using QuiCK presses
of the s4 key. The top line of the display will show the file number, the
middle and bottom lines will show the time and date the file was
captured. Every 3 seconds the display will change to show the Altitude
of the file in the middle line and Alti in the lower line. The user may
also manually advance the display using the s3 key. Use a QuiCK
press of the s1 or s2 keys to move through multiple captured files.
The number of the file will always be shown in the upper line of the
display. The file system works on a First-In Last–Out system, were the
newest files are the ones with the highest file numbers.
The Summit/Altitech is equipped with an Altitude Data Point memory system. This system allows you to
capture to memory the altitude of a particular location along with the date and time of the capture. The
Summit/Altitech is capable of storing up to 20 individual Altitude Data Points. altimeter data point memory
initiate storing data data stored
data point time and date data point altitude
altimeter data point memory
initiate storing data data stored
data point time and date data point altitude
altimeter data point memory
initiate storing data data stored
data point time and date data point altitude