Gullco KR-200-L - Manual (Page 7)

5
INSTALLATION
ELECTRICAL CONNECTION
WARNING! Ensure proper AC earth grounding of the Gullco "Kamel" power turning roll and all
auxiliary equipment (where applicable), before applying power. Failure to do so may
invalidate the Gullco Warranty.
WARNING! Before connecting the power turning roll to a power source (receptacle, outlet, etc.,)
be sure that the voltage supplied is the same as that specified on the nameplate of
the turning roll. If in doubt, DO NOT PLUG IN THE "KAMEL" ROLL. Copies of the
possible nameplates are shown below:
As the colours of the wires in the mains lead of this equipment may not correspond with the
coloured markings identifying the terminals in your plug, proceed as follows:
−
The Green & Yellow or Green wire must be connected to the terminal in the plug which is
allocated for “Earth” / “Ground”.
−
The Blue or White wire must be connected to the terminal that is allocated for “Neutral”.
−
The Brown or Black wire must be connected to the terminal that is allocated for “Live”.
230V Equipment must be installed in accordance with CEC, NEC or other applicable electrical
code.
MECHANICAL INSTALLATION
WARNING! Check to ensure that no parts have become loose during transportation.
All "Kamel" powered turning rolls are shipped from the factory completely assembled. The only
work necessary to make the unit operational is to connect electrical power, as described previously.
When setting up power and idler rolls it is good practice to align the rolls accurately. The rolls
should all be parallel and at the same elevation, with the wheels in line. It is recommended that
they be rested on a smooth, flat surface.