Greenheck Centrifugal (CSW, BIDW, AFDW), Industrial (IPA, IPO, IPW) and Filtered Supply (LSF) (463687) User Manual

Page 5

Centrifugal, Industrial and Filtered Supply

Fan

Suggested Belt Guard Attachment Points

(shaded gray)

Motor Position: W/Z

Arrangement - 1, 3

Motor Position: X/Y

Arrangement - 1, 3

Motor Position: L/R

Arrangement 9

Single-Width - Arr. 1, 3 (Motor Position W/Z)
Single-Width - Arr. 9, 10

Double-Width - Arr. 3 (Motor Position W/Z)

Single-Width - Arr. 1, 3 (Motor Position X/Y)

Double-Width - Arr. 3 (Motor Position X/Y)

Belt Guards

Greenheck offers
various types of
customized belt
guards dependent
upon fan model,
arrangement and
motor position.
Motor position is
determined from
the drive side.

The various types of belt guards are shown in
illustrations. If the guard is not purchased from
Greenheck, they must be supplied by the installer or
owner.

If the belt guard is not factory mounted or was not
supplied by Greenheck, then it must be ﬁeld mounted.
Brackets and mounting hardware are the responsibility
of the installer. The ﬁgures below illustrate suggested
attachment points for belt guard mounting bracket
locations. These locations vary with motor mounting
position, arrangement, and fan type. The bearing
supports and fan structure are used in most instances
and when the motor is not mounted to the fan
itself, a bracket should also be located near it. This
information is intended as only a guide and actual ﬁeld
conditions may dictate another mounting location for
the guard brackets. Refer to local codes for securing
guarding.