Greenheck 316SS Extension Pin Kit & Manual Quadrant Kit (474711) - Manual (Page 2)

Non-Jackshafted Dampers
Control damper should be mounted in the duct and the shaft
extension mounted onto the correct blade of the damper before
continuing with these instructions.
After Extended Shaft is Installed
1. Assemble Manual Quadrant to extension bracket
assembly (rivets provided).
2. With damper either fully open or closed, lock manual
quadrant to extended control shaft so manual quadrant
can move damper between open and closed. Note:
Tighten down bolt on manual quadrant to 250 in. lb. of
torque. Apply "OPEN" and "CLOSED" labels if damper
movement is opposite to that engraved in the manual
quadrant.
3. Set damper to desired position and tighten wing nut on
manual quadrant to hold damper in place.
Jackshafted Dampers
1. The jackshaft is, either, 1 ⁄
2
in. diameter or 1 in.
diameter depending upon the size of the damper.
The manual quadrant kit for the
1 ⁄
2
in. diameter
jackshaft is Part #862237 and the manual quadrant
kit for a 1 in. diameter jackshaft is Part #862239.
2. With damper either fully open or closed, lock
manual quadrant to jackshaft so manual quadrant
can move damper between open and closed. Note:
Tighten down bolt on manual quadrant to 250 in.
lb. of torque. Apply "OPEN" and "CLOSED" labels
if damper movement is opposite to that engraved
in the manual quadrant.
3. Set damper to desired position and tighten wing
nut on manual quadrant to hold damper in place.
Jackshafted Damper
Copyright © 2011 Greenheck Corporation
474711 SE Extension Pin Kit and Manual Quadrant
Rev. 1 Sept 2011
Part Number 862237
316SS 1/2 in. Extension Pin Kit with Manual Quadrant
No. Qty Description Part Number
1 1 1/2 in. dia. Manual Quadrant 464699
2 1 Standoff Bracket 687784
3 4 1/4-20 x 1/2 in. 316SS Bolt 415868
4 4 1/4-20 316SS Hex Nut 415835
5 1 Extended Control Shaft 463921
6 1 Retaining Clip 454204
7 2 .125 in. Rivet 416308
8 1 Label - Open/Close 452690
9 4 316SS Washer 415837
Part Number 862239
316SS 1 in. Manual Quadrant Kit
No. Qty Description Part Number
1 1 Wingnut 416132
2 1 1/2 in. 316SS Washer 415401
3 1 .375 -16 316SS Hex Nut 415799
4 1 1 in. Quadrant Lever Arm 827734
5 1 3/8 -16 x 2.5 316SS Bolt 415944
6 1 Manual Quadrant Bracket 687407
7 4 Standoff Bracket 687405
8 1 3/8-16 x 1.25 316SS Bolt 415780
9 1 Label, Open/Close 452690
10 8 1/4-20 x 1/2 316SS Bolt 415868
11 8 1/4 in. 316SS Locking Washer 415837
12 8 1/4-20 316SS Nut 415835
13 1 3/8 in. 316SS Locking Washer 415810