Grandstream GXP1160 Quick Installation Guide - Manual (Page 4)

PHONE SETUP:
To setup the GXP1160/GXP1165, follow the steps below:
1. Connect the handset and main phone case with the phone cord;
2. Connect the LAN port of the phone to the RJ-45 socket of a hub/switch or a
router (LAN side of the router) using the Ethernet cable;
3. Connect the 5V DC output plug to the power jack on the phone; plug the power
adapter into an electrical outlet. If a PoE switch is used for GXP1165 in step 2,
step 3 could be skipped;
4. The LCD will display provisioning or firmware upgrade information. Before con-
tinuing, please wait for the date/time display to show up;
5. Using the phone embedded web server or keypad configuration menu, you can
further configure the phone using either a static IP or DHCP.
Installing the phone stand:
1. Attach the phone stand to the back of the phone where there is slot for the
phone stand;
2. Pull out the tab from the handset cradle (see figure below);
3. Rotate the tab and plug it back into the slot with the extension up to hold the
handset.
Tab with extension up
Install the phone
stand to the slot on
the back.
Handset Rest
Tab with extension down
PC Port
LAN Port
Power Port
Headset Port
Handset Port
CONNECTING THE PHONE:
3 4