Connecting the phone – Grandstream GXP1610 Quick Installation Guides User Manual
Page 4

To setup the GXP1610, follow the steps below:
1. Connect the handset and main phone case with the phone cord.
2. Connect the LAN port of the phone to the RJ-45 socket of a hub/
switch or a router (LAN side of the router) using the Ethernet cable.
3. Connect the 5V DC output plug to the power jack on the phone;
plug the power adapter into an electrical outlet.
4. The LCD will display provisioning or firmware upgrade information.
Before continuing, please wait for the date/time display to show up.
5. Using the phone embedded web server or keypad configuration
menu, you can further configure the phone using either a static IP
or DHCP.
Installing the Phone (Phone Stand):
When installing the phone stand, attach the phone stand to the back
of the phone in the dedicated slots (pictured above).
Installing the Phone (Wall Mount):
1. After attaching the phone stand, attach the phone to wall via the
wall mount holes.
2. Pull out the tab from the handset rest (See figure below).
3. Rotate the tab and plug it back into the slot with the extension up to
hold the handset while the phone is mounted on the wall.
Tab with extension up
Handset Rest
Tab with extension down
CONNECTING THE PHONE:
LAN Port Power
Handset Port
PC Port
Headset Port
Slots for the phone
stand if placing the
phone on a flat sur-
face
4
3
Tips For Using the Keypad:
Message Waiting
Indicator
Line Key
Softkey
Message
Phonebook
Page/Intercom
HOME Button
Hold
Standard Keypad
Menu/OK key
Navigation keys
Record
Headset
Speaker
Volume
Send
Transfer
Mute
Conference
1. To access the MENU, press the round MENU button.
2. Navigate the menu by using the UP/DOWN and LEFT/RIGHT but-
tons.
3. Press the round MENU button to confirm a menu selection.
4. The phone automatically exits MENU mode when there is an in-
coming call, the phone goes off-hook, or when the MENU mode is
left idle for 60 seconds.