GAMMA X-Stringer X-6FS STRINGING MACHINE (Issue 1 - May 2004) - Manual (Page 7)

6
Securing the Frame
Lock the shoulder supports in position by
turning the knob at the base clockwise.
Repeat the adjustment procedure for the
remaining support post.
Re-tighten all of the frame supports in the
same order as before.
Do not overtighten any of the supports as
racquet damage may occur.
The supports should be tightened to the point
where the racquet frame will not move in the
mounting system when the handle is grasped and attempts are made to move it. Should any
supports lose contact with the frame while stringing, they should be re-tightened.
MOUNTING THE FRAME
Tightening the Frame Supports
Tighten the Frame Support Slides by turning
the adjustment knob clockwise until snug
against the racquet frame and slight resis-
tance is felt.
Caution: Overtightening the Center Sup-
ports will stretch the head of the racquet and
could cause racquet damage.
Frame Shoulder Support Adjustment
Being sure the shoulder supports are free
to swivel in their mountings, simultaneously
rotate the shoulder support adjustment knobs
clockwise until both shoulder supports gen-
tly and squarely contact the frame.