GAMMA X-Stringer X-6FS STRINGING MACHINE (Issue 1 - May 2004) - Manual (Page 5)

4
ASSEMBLY INSTRUCTIONS
Installing the Frame Support Posts
Place the support post onto the central slot
of the turntable. While holding the mounting
plate against the inside top surface of the
turntable with your fingers, align the hole in
the support post with the hole in the mounting
plate. Install the mounting bolt through the
support post and into the plate by hand and
tighten with the 6 mm hex wrench. Re-install
the turntable end caps.
Repeat procedure on the opposite side of
the turntable
Remove Mounting Bolts
While holding the mounting plate on the inside
of the turntable remove the support post
mounting bolts.
NOTE: There are two Nylon washers that
are are included for shipping purposes only.
Remove and discard the nylon washers.
Repeat procedure on the opposite side of
the turntable
Support Post Installation
To install the support posts you must first
remove the turntable end cap by grasping
the sides of the end cap and removing it, to
gain access to the inside of the turntable.
Repeat procedure on the opposite side of
the turntable.
If end caps are tight, a flat blade screw driver
may be used to pry the end caps off.
Nylon
washers