GAMMA X-Stringer X-ES STRINGING MACHINE (Issue 1 - May 2004) - Manual (Page 4)

Support Post Installation (con’t)
After removing
the mounting bolt, remove
and discard the plastic washers that are
installed for shipping purposes.
3
ASSEMBLY INSTRUCTIONS
Turntable Installation
Insert the turntable pin into the bushing of
the machine base.
Support Post Installation
To install the support posts you must first
remove the mounting bolt from the mounting
plate that sets inside the central cavity of the
turntable. There are large holes stamped on
the underside of the turntable that allow you
to support the mounting plate with your
fingers while removing the mounting bolt.
Remove and Discard Plastic Washers