GAMMA 6004 STRINGING MACHINE (Issue 3 - December 14, 2000) - Manual (Page 6)

5
ASSEMBLY INSTRUCTIONS
Turntable Installation
Position the recess in the underside of the turntable over
the flange of the turntable pin.
Frame Support Post Installation
The support post assemblies are precision aligned at
the factory and are marked for proper installation on the
turntable.
Install the marked support post on the marked side of
the turntable. Align the threaded hole in the bottom of
the support post with the slot in the turntable. Screw the
lever lock bolt with washer into the bottom of the support
post and tighten gently.Position the washer with the
rounded edge toward the turntable.
Repeat procedure on the opposite side.
NOTE: 2 pcs. of M10 cap screws (#170) are provided
with the machine in the event the lever lock bolts
become inconvenient. Simply install the M10 screws in
place of the lever lock bolts and tighten with the wrench
provided..
Attach the turntable to the turntable pin flange using the
included 4 - M6 cap screws.
Tighten securely.