GAMMA 6004 STRINGING MACHINE (Issue 3 - December 14, 2000) - Manual (Page 15)

14
Adjusting the Tensioner Brake
Step 1
After stringing many racquets, the brake of the tensioner
may need to be adjusted.
With the brake lever engaged, loosen the lock bolt
located on the back side of the tensioner frame with the
4mm hex wrench.
Note: The lock bolt should only be loosened enough to
be turned by hand and must not be removed completely.
Adjusting the Tensioner Brake
Step 2
With the lock bolt loosened and the brake lever engaged
in the latch, insert the 6 mm hex wrench through the hole
in the tensioner cover and into the (C) brake lever
adjusting bolt.
C - Brake Lever Adjustment Bolt
Adjusting the Tensioner Brake
Step 3
To tighten the braking mechanism, turn the brake lever
adjusting bolt counter clockwise by about 1/8 turn.
Retighten the lock bolt on the back side of the tensioner
frame and check for brake tightness. The tensioner
should move freely along the track with the brake lever
engaged and should hold tension with the brake lever
released. If more adjustment is needed, repeat steps
above until properly adjusted.
Note: Cover Removed For Clarity
MAINTENANCE and ADJUSTMENTS
A - Lock Bolt
A
C