Racquet balance test – GAMMA 3 in 1 Racquet Test Center User Manual

Page 6

Text mode
Original mode

Issue 1-031009

GAMMA RACQUET SPORTS

www.gammasports.com

RACQUET BALANCE TEST –

A. Fully extend the balance beam by sliding it out of its holder.

B. Place the racquet on the balance beam and rotate the beam to slide the

racquet to the right side of the table. (Note: The grip may tend to stick to the
table and cause the racquet to slip on the balance beam as the beam is turned.
If this occurs, it is best to place the racquet on the balance beam close to its
balance point from the start.)

C. Observe the end of the racquet as it slides over the table and read the balance

point off the scale where the butt end of the racquet lifts off the table.

- 5 -