GAMMA 3 in 1 Racquet Test Center - Manual (Page 11)

Issue 1-031009
GAMMA RACQUET SPORTS
www.gammasports.com
© 2009 GAMMA Sports All Rights Reserved
TROUBLESHOOTING (SWING WEIGHT) –
When performing the Swing Weight Test, it is very important that the end of the racquet or Calibration Bar be positioned against the backside of
the Racquet Clamp as illustrated in Figure 1 below.
It is equally important that the machine table be level. If the table is tilted up at the front (Figure 2) the Swing Weight measurement will be higher
than the standard. If it is tilted down (Figure 3) the Swing Weight measurement will be less than the standard.
- 10 -
Figure 1
Figure 2 Figure 3