Assembly instructions – GAMMA 3 in 1 Racquet Test Center User Manual

Page 4

Text mode
Original mode

Issue 1-031009

GAMMA RACQUET SPORTS

www.gammasports.com

ASSEMBLY INSTRUCTIONS –

A. Attach the balance beam to the machine table using the 5 mm L-shaped hex wrench.
B. Slide the weight onto the end of the calibration bar and place it in the hooks on the right side of the machine

C. Check the bull’s eye level located in the racquet clamp and adjust the footpads until the bubble is centered in the sight glass.
D. Turn the footpads clockwise to lower the level of the base and counter clockwise to raise the level of the base.
E. Make sure the voltage switch is set to the correct setting and connect the power cord to the power outlet. After switching the machine on,

wait for 3 “beeps” and then the machine will be ready to use.

- 3 -